Home > Gatsby Hot Tub > Mood Light
  • Mood light repair
  • Lens repair comes with nut.

Mood Light Housing and Nut Blue Mood Light Lens Red Mood Light Lens
Standard Mood light housing and nut.
Replaces 309002, 8018
3 1/4" Outside Diameter Lens; Hole Size: 2 7/16"

Standard BLUE Mood Light cover
3 1/4" Lens

Used on most Gatsby spas, most Jacuzzi Whirlpool Bath spas, many J-200 series spas and many more models.
Standard Red Mood Light cover
3 1/4" Lens

Used on most Gatsby spas, most Jacuzzi Whirlpool Bath spas, many J-200 series spas and many more models.
3.25" Mood Light Frame for Light Light-Mood 12v Clear Bulb Mood Light Cord
Mood Light Cord
Our Price: $5.69
White cone that holds the mood light bulb to the housing.
Replaces 6541-553

Standard clear 12v replacement bulb. Mood light cord.
Replaces 6541-553, J222-000
Mood Light

This LED light assembly plugs into hot tubs mood light that use a standard 12v bulb.

This unit will NOT work on spas with mood light that can be set to low/medium/high. It will only work on spas with on/off mood lights.

Simply unplug 12v bulb and plug in this light.

Must have clip on style connection; same as 48-144
More About Multi Color LED Most spas until 2003 have a simple on/off mood light. Until now if you want color, you purchased a Red or Blue cover lens shown above. In the early 2000's manufacturers came up with an LED light replacement. For light assemblies that have a simple 12v light bulb, you unplug the bulb and plug the LED in its place.

What do I you get? This is a 10 function, 27 LED assembly. Translation: you get 10 color settings and it uses 27 LED's to make the color. Like your TV, it uses the primary colors in mixture to make other colors.

How do you change color selection? The assembly works off a simple on/off selection. So, by turning the light activation on your spa on/off/on/off etc in rapid sequence you get different colors or color rotations. NOTE: This assembly only works well on simple on/off buttons. If you have a spa with the button in tandem to the jet action OR a light button that gives various brightness levels, this assembly will have mixed results.

How Do I install? Open side panel where the mood light is located. You should have a white cone like this over the light lens assembly. Remove by either snapping off or twisting. This will expose a standard car dome light used in early production cars. Simply pull the bulb out. Plug the new assembly in. Reverse and see your new multi color choices.